Grease Gunner
Well-known member
I was playing at work with Solidworks and designed a clamp on suppressor mount with pic rail so you can attach a SureFire Scout or similar light.
Programmed my CNC mill up today and made the prototype unit today. Between my cnc and manual mills it took some time but it looks good (least I think) I’m going to see how it looks with a SureFire Scout fits on it tomorrow to see if the offset is good or if it hangs out too far.
The nice thing about this is I can make it work on any diameter suppressor. Just have to make the bore bigger or smaller. This one is made for a 1.4” OD suppressor and I’ll be writing the code for 1.5” and 40mm suppressors.
Programmed my CNC mill up today and made the prototype unit today. Between my cnc and manual mills it took some time but it looks good (least I think) I’m going to see how it looks with a SureFire Scout fits on it tomorrow to see if the offset is good or if it hangs out too far.
The nice thing about this is I can make it work on any diameter suppressor. Just have to make the bore bigger or smaller. This one is made for a 1.4” OD suppressor and I’ll be writing the code for 1.5” and 40mm suppressors.
Attachments
-
AE9B4649-729D-4786-B8B7-25B05E4960A2.jpeg76 KB · Views: 11
-
C8440570-DCA4-4107-AF16-F5BD1DA93235.jpeg86.2 KB · Views: 12
-
8E812BF1-46B6-424E-A3D7-0FEFE2540527.jpeg98.7 KB · Views: 12
-
BC574E2C-7043-48F2-A93F-09D73DE86642.jpeg95.5 KB · Views: 12
-
29F6AB9F-EFD4-4018-A5A8-D6A7E687EB63.jpeg117.2 KB · Views: 11