Register a free account today to become a member! Once signed in, you'll be able to participate on this site by adding your own topics and posts, as well as connect with other members through your own private inbox!
I had planned on doing the clip and pin on a really nice SEF lower I picked up but the Century receiver is so out of spec the new grip wont fit.
The section around the stock attach pin tube is too wide. It's .031" wider than my HK91 at the same place.
I worked on the 33Klone all day yesterday. Repainted everything, that's the end cap Elkaholic welded for me.
He didn't just attach the sling loop, he also made & installed that little "cup" which keeps the recoil spring rod in place.
Propped up on my last case of Guatemalan milsurp ammo...
I'm trying hard to keep from typing "I hate you" again.
Do you do your own cerakote or do you send them out?
Timely as I'm about to start a thread asking about gun finishing.
I liked the little smirk you gave the camera after the mag dump.
I had a similar problem with my C93. I bought some new, German mags and they wouldn't lock in without applying an amount of force that made me nervous.
An intelligent person would have removed the 20 dollar magazine catch and sanded on the upper edge slightly.
I chose to grind on a seventy...
It was cloudy and gray yesterday. but today was a beautiful day at the range.
I brought the K, C93, FAL, and the Hawken.
Two range trips in a week, that's some kinda record.
Hey! That reminds me of my ex-wife; Twice in one month darling, aren't I lucky.
223 is so nice to shoot compared to...
Thanks for the kind words.
Went to the range yesterday, I'm please to report that it ran great. Accurate too.
I didn't think there would be any problems. I found a chart online that said the 33s used the same LP as the full length rifles.
There's a place ten minutes from my house that does SBR...
I had a plastic slim handguard in my stash that someone had opened the slots in.
I think I paid ten bucks for it. I shortened it too. I cut it on my table saw and used CA (superglue) to join the pieces.
I have a nice one coming from MKE, I just wanted to try this. It looks good from ten feet away!
So many acronyms. so little time.
I set right to work yesterday after getting my approval. I had read about WECSOGing a barrel shortening job by using progressively smaller dies and removing the thread between passes.
I did this once years ago to a Century FAL and it worked perfectly.
I would...